Replacing the light bulb | Miele T 7644 C guide

Trouble shooting

Replacing the light bulb

Disconnect the dryer from the electrical supply.

Open the door.

The bulb should be of the same type and maximum wattage indicated on the data plate and the lighting cover.

Replace the bulb.

The hinged cover for the lighting is over the port-hole.

Gently insert an ordinary tool* under the side of the cover.

* such as a wide slot-type screwdriver

Open the cover by pressing lightly while rotating your wrist.

The cover opens downwards.

The heat-resistant bulb should be obtained only from Miele customer ser- vice.

Fold the cover upwards and press it on the right and left until you hear it latch.

Ensure that the cover is properly seated. If moisture gets inside it may cause a short-circuit.

34

Image 34

Miele T 7644 C operating instructions Replacing the light bulb

Contents

Operating Instructions For condenser tumble dryer T 7644 C Disposing of your old appliance Caring for the environmentDisposal of packing material Saving energy Contents Contents Important Safety Instructions This dryer is intended for residential use only Grounding Instructions Accessories Operating the dryer Dear Customer Main FeaturesDescription Function of Miele condenser dryer To do all this, the dryer is equipped with systems Laundry care anti-crease action and roll-up prevention Control panel Fault indicator / Optical interfaceOperating the dryer Display Program duration/ Estimated time remaining DelayProgrammable functions Drying tips Care symbolsLaundry care Drying Laundry care Preparing the laundry Proper dryingBrief instructions Turn on the dryer Select program Extra options/Select DelayDryness level selection in programs Before the end of a program Starting the programEnd of program Remove laundry Gentle Options/DelayDelay Buzzer Hand iron, Rotary iron Program OverviewNormal Extra dry, Normal Wrinkle-free Extra dry, Normal, Hand iron Express Normal, Hand iron WoolensSmoothing Dress shirts Normal, Hand iron Timed cold Timed warm Loading or removing laundry Switching over from a running programChanging the program sequence Time remaining Activating the lock Electronic lockDeactivating the lock Cleaning and care Emptying the condensed water container Cleaning the lint filtration components Cleaning without water Cleaning the dryer Cleaning with water Cleaning the condenser heat exchanger unit Removing the condenser unit Checking the condenser unit Replacing the condenser unit Handle of the unit must be on top, the locking lever down Test and fault messages Trouble shootingWhat to do, if . . . ? Canceling the fault Problem Cause SolutionCanceling test Container indicator light Other problems Dryer after Problem Cause Solution Water runs fromCleaned Condenser has been Cold programs will not Start and the indicatorWhen switched on Lights for these programs Replacing the light bulb Warranty conditions and warranty period Customer serviceProgram updates Optional accessories Installation and connection Front view Carrying the dryer to the installation site Rear view Installation siteWasher-dryer stack Leveling the dryer Ventilating the installation area Before transport at a later date General Draining condensed water externallyArranging the drain hose Special installation conditions requiring a non-return valve Hooking up the drain hose in sink or floor drain Installation and connection Electrical connections Technical data Programmable functions for changing Standard values Programmable functions Extending the range of drying levels Buzzer normal default setting Buzzer loud Adjusting buzzer volumeFor programming and saving in memory, follow steps to Set memory function No Memory default settingMemory Extending cooldown time Default setting Change function of Filter/Vent indication Adjust keypad tone No Keypad tone default setting Keypad tone on Default setting Lower conductivity setting Changing water conductivity settingImportant condition Page Page Page Alteration rights reserved Nr 323 260