Operating the tumble dryer
Display h min
The display shows:
–the programme duration (h min = hours and minutes)
–Check and fault messages
–Settings
The settings are used to tailor the dryer's electronics to suit your individual requirements.
See "Settings" for more information.
Estimated time remaining
After the start of a programme the estimated programme duration will appear in the h min display in hours and minutes (estimated time remaining). The only exception to this are the Timed drying programmes which last for 20 minutes.
The estimated duration (time remaining) will appear in the display. The following factors all affect the estimated time remaining: residual moisture content after spinning; type of fabric; size of load; room temperature; fluctuations in power supply. The electronics continually assess conditions in the appliance and adjust the estimated time remaining for a more accurate reading. Because of this, the time displayed can alter during the course of a programme. Programmes can also finish earlier than expected, if, for example, particularly fine fabric is being dried, the load is very small or items were partially dry beforehand.
Drum lighting
If the dryer is switched on at the mains and the door is opened, the drum lighting will come on. It will go out a few minutes later to save energy.
Before using for the first time
Ensure that the dryer is installed and connected to the electricity supply correctly. If the tumble dryer has not been transported as described in "Installation and connection" then it must be left to stand for at least 1 hour before it is connected to the electricity supply.
15
