Settings
Adjusting the dryer's electronics for very soft water
This setting should only be altered if the water is so soft that it is likely to cause the electronics which sense residual moisture in the laundry to give false readings.
Important
If the dryer is installed in an area with very soft water, you should contact your local water supplier for information and advice regarding water hardness and water conductivity. If the water conductivity is less than 150 μS, the following setting will need to be activated.
Only activate this programmable function if these conditions are present. Otherwise drying results will be unsatisfactory.
Follow steps (,, ...) to programme and store in memory.
Before you begin, ensure that:
–The tumble dryer is switched off.
–The door is closed.
–The programme selector is pointing to Finish.
Press Start and keep it pressed in whilst carrying out steps
Switch the dryer on.
Wait until the indicator light for the Start button comes on . . .
. . . and then release the Start button.
Turn the programme selector to
Gentle smoothing.
The Empty container indicator light will flash on and off slowly once and then on and off quickly twice.
The option selected will be displayed by a number which will alternate with .
Factory default setting
Adjusted for very soft water (with low conductivity)
(The Clean out airways indicator light will also flash once)
Pressing the Start button switches between the options.
Switch the dryer off.
The setting you have selected is now stored in memory. You can change it again at any time.
To check the setting:
Carry out steps -.
Switch the dryer off after checking.
52
