Port Configuration
3-65
3
Forced Mode1 – Shows the forced/preferred port type to use for combination ports
21-24. (Copper-Forced, Copper-Preferred-Auto, SFP-Forced, SFP-Preferred-Auto)
Trunk Member1 – Shows if port is a trunk member.
Creation2 – Shows if a trunk is manually configured or dynamically set via LACP.
Web – Click Port, Port Information or Trunk Information.
Figure3-39 Port - Port Information
Field Attributes (CLI)
Basic information:
Port type – Indicates the port type. (1000BASE-T or SFP)
MAC address – The physical layer address for this port. (To access this item on
the web, see “Setting the Switch’s IP Address” on page 3-13.)
Configuration:
Name – Interface label.
Port admin – Shows if the interface is enabled or disabled (i.e., up or down).
Speed-duplex
– Shows the current speed and duplex mode. (Auto, or fixed choice)
Capabilities – Specifies the capabilities to be advertised for a port during
auto-negotiation. (To access this item on the web, see “Configuring Interface
Connections” on page 3-48.) The following capabilities are supported.
10half - Supports 10 Mbps half-duplex operation
10full - Supports 10 Mbps full-duplex operation
100half - Supports 100 Mbps half-duplex operation
100full - Supports 100 Mbps full-duplex operation
1000full - Supports 1000 Mbps full-duplex operation
Sym - Transmits and receives pause frames for flow control
FC - Supports flow control
1. Port Information only.
2. Trunk Information only.