Command Line Interface
4-18
4
Command Usage
Set the speed to match the baud rate of the device connected to the serial
port. Some baud rates available on devices connected to the port might not be
supported. The system indicates if the speed you selected is not supported. If
you select the “auto” option, the switch will automatically detect the baud rate
configured on the attached terminal, and adjust the speed accordingly.
Example
To specify 57600 bps, enter this command:
stopbits
This command sets the number of the stop bits transmitted per byte. Use the no
form to restore the default setting.
Syntax
stopbits {1 | 2}
• 1 - One stop bit
• 2 - Two stop bits
Default Setting
1 stop bit
Command Mode
Line Configuration
Example
To specify 2 stop bits, enter this command:
disconnect
Use this command to terminate an SSH, Telnet, or console connection.
Syntax
disconnect session-id
session-id – The session identifier for an SSH, Telnet or console
connection. (Range: 0-4)
Command Mode
Privileged Exec
Console(config-line)#speed 57600
Console(config-line)#
Console(config-line)#stopbits 2
Console(config-line)#