Miller Electric S-74DX manual Setting Sequence Parameters, Sequence Parameters In a Program

SECTION 7 − SETTING SEQUENCE PARAMETERS

7-1. Sequence Parameters In A Program

	Sequence		Parameters
		Volts	IPM	Seconds
1.	Preflow			0-9.9
2.	Run-In		X
3.	Start	X	X	0.00-5.00
4.	Weld	X	X	0-100.0
5.	Crater	X	X	0-5.00
6.	Burnback	X		0-0.25
7. Postflow				0-9.9
X = Setting available.

.For more information on

Sequence Push Button see Section 6-9.

If time is set to zero in Weld sequence, welding continues until gun trigger is released.

If time is set to zero in any timed sequence except Weld, the sequence is skipped.

				Weld Time
				Crater
				Time
					Burnback
		Start			Time
	Preflow	Time			Postflow
	Time				Time
						Time
				Burnback		Sequence
Preflow	Run-In	Start	Weld	Crater	Postflow
						End
Trigger				Trigger
Pressed				Released

OM-1500-9 Page 25