Miller Electric XMT 400 manual Troubleshooting, Remote 14 receptacle, Reset circuit breaker CB1

6-4. Troubleshooting

	Trouble		Remedy
No weld output; unit completely inop-		Place line disconnect switch in On position (see Section 4-9).
erative.
		Check and replace line fuse(s), if necessary, or reset circuit breaker (see Section 4-9).
		Check for proper input power connections (see Section 4-9).
No weld output; meter display On.		If using remote control, be sure Mode Selector switch is in a position that provides output control at
		Remote 14 receptacle.
		Check, repair, or replace remote control.
		Unit overheated. Allow unit to cool with fan On (see Section 4-2).
Erratic or improper weld output.		Use proper size and type of weld cable (see Section 4-6).
		Clean and tighten all weld connections.
No 110 volts ac output at duplex recep-		Reset circuit breaker CB1.
tacle, Remote 14 receptacle.
No 24 volts ac output at Remote 14 re-		Reset circuit breaker CB2.
ceptacle.

OM-217 769 Page 26