inspection plate and use a timber to pry up the cylinder to remove cylinder weight from the bearings. Once the bearing is removed, the cylinder drops only approximately 1/32" before the shaft comes to rest on the shaft support.
4.Slide the bearing off of the shaft and if it is to be reused, place it on a clean surface and cover with a clean, lint free cloth.
Removing the Bearing Housing (Bearing and Seal Carrier), Seal Sleeve, and Seals (Front or Rear)
These procedures require the use of a pulling fixture and guide rods available from the Milnor® factory. With the bearing cover (or shaft seal holder) and the bearing removed, proceed as follows:
1.Remove the three bearing housing cap bolts and the grease lines from the bearing housing front plate. Install guide rods in two of the bolt holes, as shown in FIGURE 3.
2.Install the pulling fixture as shown in FIGURE 4, by placing each of the four threaded rods through a hole in the steel plate with hexnuts to the outside of the plate then screwing each rod into the appropriate tapped hole in the bearing housing (same holes as used to mount the bearing cover or shaft seal holder).
FIGURE 3 (MSSM0303AE) | FIGURE 4 (MSSM0303AE) |
Two Bearing Housing Guide | Bearing Housing Pulling |
Rods in Position | Fixture in Position |
12
