Features and Controls
Read this Operator’s Manual and safety rules before operating your generator.
Compare the illustrations with your generator, to familiarize yourself with the locations of various controls and adjustments. Save this manual for future reference.
A
B
C
D
E
F
G
H
J
K
V
U
T
S
R
P
N
M
L
A - Circuit Breakers (AC) — The receptacles are provided with circuit breakers to protect the generator against electrical overload.
B - Idle Control Switch — Use this switch to turn the idle control feature on and off.
C - Engine Switch — Set this switch to “On” before using recoil starter. Set switch to “Off” to stop engine.
D - Double Pole Circuit Breaker (AC) — A double pole circuit breaker is provided to protect the 120/240V, 20A receptacle against electrical overload.
E - GFCI Main Circuit Breaker — A GFCI circuit breaker is provided to protect against electrical ground fault and protect the generator against electrical overload.
F - 120/240 Volt AC, 30 Amp Locking Receptacle — May be used to supply electrical power for the operation of 120 and/or 240 Volt AC, 30 Amp, single phase, 60 Hz electrical, lighting, appliance, tool and motor loads.
G - 120 Volt AC, 30 Amp Locking Receptacle — May be used to supply electrical power for the operation of
120 Volt AC, 30 Amp, single phase, 60 Hz electrical lighting, appliance, tool and motor loads.
H - 120 Volt AC, 20 Amp Locking Receptacle — May be used to supply electrical power for the operation of
120 Volt AC, 20 Amp, single phase, 60 Hz electrical lighting, appliance, tool and motor loads.
J - 120 Volt AC, 20 Amp, Duplex Receptacles — May be used to supply electrical power for the operation of 120 Volt AC, 20 Amp, single phase, 60 Hz electrical, lighting, appliance, tool, and motor loads.
K - Grounding Fastener — Consult your local agency having jurisdiction for grounding requirements in your area.
L - Spark Arrester Muffler — Exhaust muffler lowers engine noise and is equipped with a spark arrester screen.
M - Air Cleaner — Protects engine by filtering dust and debris out of intake air.
N - Oil Fill Cap/Dipstick — Check and add engine oil here. P - Recoil Starter — Used to start the engine.
R - Engine Identification — Provides model, type and code of engine. Please have these readily available if calling for assistance.
S - Fuel Valve — Used to turn fuel supply on and off to engine.
T - Choke Lever — Used when starting a cold engine. U - Fuel Tank — Capacity of 7.5 U.S. gallons (28.4 L).
V - Center Point Lift — The lift point in the center of the unit makes lifting the machine for transportation and/or relocation easy.
Items Not Shown:
Data Tag — Provides model, revision, and serial number of generator. Please have these readily available when calling for assistance.
Oil Drain Plug — Drain engine oil here.
www.milwaukeetool.com
