8
Plug the two rubber wash ers into the holes
on either side of the lower shaft yoke.
Slide the yoke into the yoke brac ket on top
of the coil. Ensure that the spri ng loaded
pin in the lower shaft is u nderneath.
Insert the plastic bo lt through the yoke
and the yoke bracket.
Fasten with the plastic wing nut provided,
being careful not to dama ge the thread
of the bolt by over-tightening. This may
need to be loosened to a djust the coil to
a comfortable detec ting angle.
The coil cable is directly wired into the
coil and is not removable. Any attempt to
disconnect this cable will void your warranty.