DS VISION 3000
System In
CATx cable from
Transmitter/Broadcaster or
Line Splitter/L or Receiver
DCL unit
Screen 1 | Serial port / |
| device |
System Out
CATx cable to Line Splitter/L or Receiver* unit
Screen 2
Serial port / device
|
| Receiver | SYSTEMIN | SYSTEMOUT | SERIAL 1 | SERIAL 2 | 5VDC | |
|
| DCL side 1 |
|
|
|
|
| |
|
|
|
|
| 1 | 2 |
|
|
|
| Receiver | TUNING | AUDIO | VIDEO 1 |
| VIDEO 2 | |
Video | Speakers / | DCL side 2 |
|
|
|
|
| |
| Audio |
|
|
|
|
|
|
|
* Receivers refers to any of the following:
Receivers
Receivers L
Receivers DCL
Speakers /
Video Audio
Figure 22 Receiver DCL connections
Connecting CATx cables
The connections are illustrated in Figure 21 and Figure 22 above.
Connecting the Broadcaster/Transmitter
Connect CATx cables to the System ports of the Broadcaster/Transmitter and the System In ports of Receivers/L/DCL or Line Splitters/L.
Connecting/cascading a Line Splitter/L
Connect CATx cables to the System Out ports of the Line Splitter/L and the System In ports of Receivers/L/DCL or further Line Splitters/L.
Cascading a Receiver DCL
Connect a CATx cable to the System Out port of the Receiver DCL and the System In port of a Receiver/L/DCL or Line Splitter/L.
Connecting to the power supply
Connect the Transmitter/Broadcaster and all Receiver and Line Splitter units to the power supply using the AC/DC adapters provided. If using third party power adapters, ensure correct polarity (Center negative) and voltage – see the Tech specs.
Once the system is connected the DS Vision system broadcasts to all remote monitors/speakers. Note! You can use the Service Utility provided to broadcast content to specific monitors or groups of monitors, see DS Vision system management on page 19 below.
17
