2-11
6. Auxiliary Functions
Getting to Know Your Copier Chapter 2
If an access number has been programmed, it
allows only particular persons to use the copier or
a supervisor to keep track of the number of copies
made by a particular department.
NOTES
•If an access number has been programmed, a
copy cycle can be initiated only after the access
number has been input to the copier.
•Before you can use this function, you must first
turn “ON” the “Copy Track” function of the
Administrator Mode available from User’s
Choice. ☞p.5-3
Entering the Access Number
Using the 10-Key Pad, enter the 4-digit
access number and press the OK Key.
NOTE
To correct the 4-digit access number entered,
first press the Clear Key, then enter the new
number.
The Touch Panel changes from the “Access
#” prompt to the initial screen. A copy cycle
can now be started. Make your copies as
necessary.
When the copy cycle is completed, press the
Access Mode Key to go to the “Access #
Prompt Screen.”

Access Number

<“Access #” Prompt Screen>
1154P449CA
1
1154O401
123
456
789
0C
2
3