GUIDE TO INSTALLATION AND OPERATION
4.3.1 Connector panel installation
Remove the blank panel (a blank panel is used to occupy the rear panel space behind empty slots) or existing connector panel. Release the captive screws at the top and bottom, and pull the panel straight out of the frame.
Slide the new connector panel into the slot on the rear of the frame. Push it gently into position until the panel is tight against the frame and flush with the remaining panels. Fasten it into position with the captive screws at the top and bottom. DO NOT over tighten the captive screws.
4.3.2 Module card installation
Open the front panel of the frame and locate a slot corresponding to the module. Note that a color code helps to identify where a module should be installed (figure 4.4.2.1). All cards except the controller card are removed by pulling up the swivel handle, which levers the card away from the mother board, and then pulling the card out of the slot using the handle.
To install the new card, slide it into the slot, engage the swivel handle into the top panel hole and push gently on the handle to seat the connectors into the mother board. Do not force the card into place.
Note: As the output card has an
The Controller Module is a larger
Note: Due to the weight of the Controller module assembly, you must loosen the two screws holding the rear module - without removing it - before attempting to insert the Controller module.
Apart from the Controller card described above, and the GPI card which is installed in the adjacent slot, all other cards are either video input cards, audio input cards, or output cards. They fit into slots designated by type, which are indicated by text and color along the bottom front of the frame, as follows (slot positions counted from the left):
Position | Module type | Color Code | |
1 |
| Controller | White |
2 |
| GPI | Grey |
3 | – 5 | Audio input | Blue |
6 |
| Output | Yellow |
7 | – 14 | Video input | Green |
15 | Output | Yellow | |
Figure 4.3.2.1 Color coding label
8 Kaleido K2
