3. TV Features 23
For assistance call 1(800) 332-2119

Microphone Placement

Be sure the

height of the

microphone is

within three feet

of the speaker

height.

Center the micro-

phone in front of

the TV.

Set the microphone

on a level surface at

ear height at least

six feet from the TV.

Use a seat backrest

or tripod so as to

pick up sound from

all directions.

Maximum height above speakers

Microphone

TV

6 ft. minimum

Microphone

Height of TV

speakers

3 ft.

Sound Projector, continued
Adjusting Beam Angles

3.

a. Adjust Center Beam Angle until sound is
about equal in both ears.
b. Adjust Left Beam Angle to maximize sound
heard from the front left side.
c. Adjust Right Beam Angle to maximize sound
heard from the front right side.
d. Adjust Left Surround Beam Angle to where
the sound seems to come from the left rear
side. If this cannot be achieved, make the
setting the same as that for Left Beam Angle.
e. Adjust Right Surround Beam Angle to where
the sound seems to come from the right rear
side. If this cannot be achieved, make the
setting the same as that for Right Beam Angle.
Adjusting Levels

4.

a. Adjust Center Level to the mid level.
b. Adjust the following levels one at a time so that
each one sounds about the same as the center
level:
Left Level
Right Level
Left Surround Level
Right Surround Level
c. Check all sound levels by quickly switching
between them using .
d. Readjust individual levels in small increments
and recheck as above until all sound levels
seem about the same.

Resetting Angle and Level Values in the

Custom Menu

Press

1.

EXIT
to clear all menus.
Press

2.

MENU.
Go to the Sound > SoundPro menu
and press
ENTER
.
Change any setting (e.g.,

3.

TV Location).
Press

4.

EXIT
to clear all menus.
Press

5.

MENU.
Go to the Sound > SoundPro menu
and press
ENTER
.
Enter the correct values for the room layout.

6.

Return to the

7.

CUSTOM menu to adjust angles and
levels.

Auto Setup

265 Series
This section describes auto-setup available with 265 serie s
TVs.
Auto setup uses the included calibration micro-
phone.
Power on the TV and external subwoofer, if any.

1.

Plug the microphone cable into the TV’s
2. INPUT 2
left audio jack.
Place the microphone as described in the guide-

3.

lines.
Press

4.

MENU
and go to Sound > AutoSP.
Highlight

5.

STAR T and press
ENTER
.
Quietly exit the room right away. The calibration

6.

sequence may be loud.
Wait for completion of setup
before returning to the room.
Play some sample audio material to check the

7.

sound quality.
Note: Do not perform manual adjustments after run-
ning Auto setup.
Store the microphone out of direct sunlight and

8.

away from heat.