403. TV Features
Sound Projector, continued
Auto Setup
265 Series
Auto setup uses the included calibration microphone to optimize Sound Projector performance for most room conditions.
Initial Preparation
1. | Position and connect the TV as described under |
| “Before You Begin,” page 38. |
2. | Power on the TV and external subwoofer, if any. |
3. | Plug the microphone cable into the TV’s INPUT 3 |
| left audio jack. |
Microphone Placement
•Make sure there are no large obstacles between the TV and microphone.
•Place the microphone
4. Place the microphone as described in the guide- |
lines on this page. |
Start Auto Setup
5. Press MENU and go to Sound > AutoSP. |
TV
6 ft. minimum
Microphone
Set the microphone on a level surface at ear height at least six feet from the TV. Use a seat backrest or tripod so as to pick up sound from all directions.
Maximum height above speakers
6. | Highlight START and press ENTER. |
7. | Quietly exit the room right away. The calibration |
| sequence will start in a few seconds and may be |
| loud. It is important to leave the room as your pres- |
| ence will interfere with the calibration process. |
8. | Wait for completion of setup before returning to the room. |
9. | Play some sample audio material to check the |
| sound quality. |
Note: Do not perform manual adjustments after run- ning Auto setup, as this will erase all settings defined during Auto setup.
10.Store the microphone out of direct sunlight and away from heat.
Height of TV speakers 
Be sure the 3 ft. height of the
microphone is within three feet of the speaker height.
Microphone
Center the micro- phone in front of the TV.
DownloadedFor assistanceFrom
