ERROR MESSAGES AND COUNTERMEASURES
OVERCOMING PAPER JAMS
1Press the DOOR OPEN button to open the door.
Make sure that the power is turned on before opening the door.
If the door does not open, turn off the power and turn it on again.
Then press the DOOR OPEN button again.
2Remove the ink cassette.
Thermal head (inside)
Push down the ink cassette as shown by the arrow 1 and pull it out.
2
1
3Take out the print paper.
When taking the print paper out, pull it up toward you.
4Cut off the defective part of the print paper with scissors.
NOTE
•Make sure to cut off the printed part of the print paper. Failure to do this may result in the ink ribbon sticking to the print paper and being torn.
•Make sure to clean the thermal head and the roller. Refer to “CLEANING” (on pages
21 and 22).
5Install the print paper and the ink cassette with the ink ribbon. (Refer to pages
6Push the center of the door to close.
The print paper setting is initialized two seconds after you close the door. |
|
|
When the auto feed & cut mode has been selected, the FEED & CUT procedure is |
|
|
repeated three times after you close the door. When the print paper with the post card |
|
|
printing on its reverse side is installed, the FEED & CUT procedure is repeated five | DOOR OPEN | CANCEL FEED&CUT |
times.
2When the manual & cut mode has been selected
When the manual feed & cut mode has been selected, hold down the FEED & CUT button for 1 second or longer. Repeat the manual feed & cut three times. When the print paper with the post card printing on its reverse side is installed, repeat this procedure five times.
For how to select the auto feed & cut mode, see "Setting of DIP switches" (on page 10).
PRECAUTIONS | |
FEATURES | |
CONNECTIONSPREPARATION | |
SHOOTING | TROUBLE- |
OTHERS | |
CONTENTS
19
