14.3.4 MUSIC ROUTING
4.1Main menu selection
Select from the main menu by means of the left/right arrow keys:
MUSIC ROUTING.
4.2Zone selection
The current music routing will be displayed. Zones which are already selected are indicated on the display by 1, not selected zones are indicated by a 0.
The lower right of the display shows the number of the zone indicated by the cursor position. Moving the cursor to another zone can be done with the left/right arrow keys. Shifting the cursor to the right, further than the last position, will display the routing of zones
Return to ‘RUN’ mode
User Programming is now completed. Pressing BREAK will exit the user programming mode, and return to the normal ‘RUN’ mode.
14.4ERROR MESSAGES
During normal operation, all modules present in the system are continuously tested. If a module stops communicating with the processor, a message is sent to the display stating the faulty module type and the module number. If a Call Station stops communicating with the system, this is also displayed. If a Control Relay Module is present, an SM30 system fault will deactivate relay 1, providing the possibility to switch on a remote warning light, buzzer, etc..
** ERROR **
CALL STATION:XX
MUSIC INPUT MOD
LINE OUTPUT MOD
CST INPUT MOD XX
MIC INPUT MOD XX
ZONE REL. MOD XX CTL RELAY MOD REC MESSAGE MOD CTL INPUT MOD XX
If more then 1 error occurs, the different messages will be displayed sequentially. When the Recorded Message Module is installed, but the mode switch is not set in the ‘SYS’ position, the following message will be displayed:
** ERROR **
MESSAGE MODULE
SWITCH POSITION
4
SELECT PROGRAM :
MUSIC R OUTING
1
MUSIC R OUTING
000000 ZONE : 01
2
Music Routing
47
