Philips SM30 Function Key number selection, Key programming selection, Key Priority selection

Relay 1 (marked ‘X’) is reserved for the activation of error indicators, if a processor failure is detected, and cannot be programmed for any other function. Relay 2 (marked ‘X’) is reserved for the activation of error indicators, if a Call Station or module failure is detected, and cannot be programmed for any other function.

Relay 3 is dedicated to the ‘Delayed Power On’ function explained in paragraph 5 ‘Programming Power On Delay’, but may be used for other functions if ‘Power On Delay’ is not used. If it is used, the third position will be marked with an ‘X’ in the display. Relay 4-6 (marked ‘O’) are not selected.

If Control Relays are to be used for alternative functions, refer to program step

1.15.Pressing BREAK will return to Key Pad selection.

1.8Function Key number selection

Selection of the Function Key number can be made with the up/down arrow keys. The display sequence is:

KEYPAD, FUNCTION KEY: F1, F2, F3, F4

1.9F-key programming selection

Each Function Key on a Call Station can be used for activation of one of two main purposes:

■Call Programming after pressing ENTER.

■Remote control of the Music and Control Relay functions to be selected by means of the left/right arrow keys (see program step 1.15 and 1.22).

1.10F-key Priority selection

See program step 1.4.

1.11F-key Signal number selection

See program step 1.5.

1.12F-key Pre-recorded Message number selection

See program step 1.6.

1.13F-key Call Routing to Zones

The current programmed call routing will be displayed.

The lower right of the display will show the zone number which is being indicated by the cursor.

Moving the cursor to a different zone can be done with the left/right arrow keys. Shifting the cursor to the right, further than the last position, will display the routing of zones 7- 12, if Zone Relay Module 2 is present.

Shifting the cursor to the right again, further than the last position, will display the routing of zones 13-18, if Zone Relay Module 3 is present.

If only Zone Relay Modules 1 and 3 are present, the routing of zones 13-18 will be displayed instead of 7-12. On the display, zones which are already selected are indicated by 1, non-selected zones are indicated by 0.

Selecting a zone can be done with the ‘’ key. Deselecting a zone can be done with the ‘O’ key.

1.14F-key programming Control Relays

See program step 1.7.

Programming of alternative Function Key Each Function Key on a Call Station can be used for one of two main purposes.

Instead of selection of Call Programming (program step 1.9) , each Function Key can

38