14.6SETUP PROGRAMMING
If the memory is clear, the software must be able to recognise the hardware that is installed before programming can be undertaken.
This is done via the Setup Program, which stores the system hardware setup in memory, telling the processor which modules and Call Stations are present in the system.
Also the display language version has to be selected the first time.
1 System down
When an SM30 system is first delivered, the relevant modules have been installed, and the system is switched on, the LCD display on the front panel will show that the system is down.
2 Installer mode
If the memory has been cleared and the User Programming password is entered, the display will show that the installer mode is first required.
To enter the Setup Program, the Installer Program password must be typed.
3 Language selection
The display will show the current language. Select the desired language by scrolling through the menu using the up/down arrow keys.
4 Store hardware
After pressing ENTER, programming continues with storing the hardware configuration.
5 Busy storing
After pressing ENTER, the display will show busy storing for a short moment.
6 Display software version
When the hardware setup is stored, the setup is complete and programming will automatically continue with the first step of the Installer Programming. First the display will show the current software version.
7 Main menu
After a few seconds, the display will show the first step from the main menu.
The main menu can always be recognised by “SELECT PROGRAM:” in the upper line of the display. Scrolling through the menu can be done with the left/right arrow keys. The SM30 system can be programmed now by the installer to suit the requirements of the user.
14.7INSTALLER PROGRAMMING
To enter the Installer Programming mode, type in the Installer password.
The display will show the Software Version x.xx, and after a few seconds the display is replaced by SELECT PROGRAM: CALL STATIONS
This is the first program step of the main menu. Refer to User Programming step numbers:
1CALL STATIONS
2MICROPHONES
3CONTROL INPUTS
4MUSIC SOURCES
3
