Mitsubishi Electronics HC4900 user manual Preparing your projector, Checking accessories

Preparing your projector

Checking accessories

The following accessories are provided with this projector. Check to be sure that all of the accessories are packed in the package.

„ Cables		„ Power supply parts
Mini D-SUB
15-pin	D-SUB
	9-pin
Mini D-SUB	D-SUB
15-pin
	9-pin
RGB cable for PC	RS-232C cable	Power cord (two)
(246C521-10)	(246C548-10)
		(246C483-10, 246C383-20)

•Used for projector control by computer.

„ Remote control parts „ Others

• Lens cap (attached to the projector)

• Lamp replacement tray (857C106-10)

• User Manual/Quick Start up (English only) (871D494-40)

• CD-ROM (with User Manual) (919C154-30)

• Safety Manual/Quick Start up (871D489-30)

Remote control	R6P (Size-AA)
(290P150-10)	battery (two)

Important:

• The attached power cords are to be used exclusively for this product. Never use them for other products.

Inserting the batteries into the remote control

1		1.	Remove the back lid of the remote control.
	3	2.	Check the polarity (+), (-) of the batteries, and set them
			correctly, inserting their (-) side first.
			• If the battery is inserted from the (+) side first, inserting
			the (-) side is difficult because the coil spring end hits
	2		on the battery side. If the battery is forced in this way,
			the outer label of the battery may get ripped and it may
			cause a short-circuit and heating.
		3.	Attach the back lid.
		Important:
		•	Use two size-AA batteries (R6P).
		•	Replace the two batteries with new ones when the remote
			control is slow to respond.

Caution:

•Use of a battery of wrong type may cause explosion.

•Only Carbon-Zinc or Alkaline-Manganese Dioxide type batteries should be used.

•Dispose of used batteries according to your local regulations.

•Batteries may explode if misused. Do not recharge, disassemble, or throw them in fire.

•Be sure to handle the batteries according to the instructions.

•Load the batteries with its positive (+) and negative (-) sides correctly oriented as indicated on the remote control.

•Keep batteries out of reach of children and pets.

•Remove the batteries, if the remote control is not used for a long time.

•Do not combine a new battery with an old one.

•If the solution of batteries comes in contact with your skin or clothes, rinse with water. If the solution comes in contact with your eyes, rinse them with water and then consult your doctor.

EN-6