EN-10 | Mitsubishi Electronics HL650U manual

Preparation/SetUp (continued)

Setting the LAN control (LAN-Controlled Mode)

1

Enter “3” and press the Enter key.

2

To enable the e-mail notiﬁcation function of Projector- View, enter 1 and press the Enter key. (Default is OFF (0).) (See pages 12 - 15 for ProjectorView function.)

Setting the PJLink™ certiﬁcation (PJLink certiﬁcation Mode)

1

Enter “5” and press the Enter key.

•When you don’t use PJLink™ protocol communication, skip this item. (See page 16 for PJLink™.)

2

To enable the PJLink™ certiﬁcation, enter “1” and press the Enter key. To disable it, enter “0” and press the Enter key. (Default is ON (1).)

EN-10

Image 10

Mitsubishi Electronics HL650U user manual Setting the LAN control LAN-Controlled Mode, EN-10

Contents

LAN Control Utility Contents Major functions Preparation/SetUpPreparation before using the network function System requirements Connection InstallationPreparation/SetUp EN-3 How to remove Mitsubishi Projector Control Device Installer EN-4 Setting the IP address of the projector EN-5 When using a Dhcp server EN-6 When not using a Dhcp server EN-7 Telnet setting EN-8 Setting the display language of ProjectorView language Setting the password Password SetupEN-9 Setting the PJLink certiﬁcation PJLink certiﬁcation Mode Setting the LAN control LAN-Controlled ModeEN-10 Save and exit EN-11 ProjectorView Using the ProjectorViewHow to start up EN-12 ProjectorView main screen ProjectorViewEN-13 Mail notiﬁcation function ProjectorView Virtual Remote controllerEN-14 ProjectorView Initial setting EN-15 Support for the PJLink function EN-16 Terms and deﬁnitions Support for the PJLink functionEN-17