ProjectorView (continued)
VIRTUAL REMOTE controller
Put a checkmark in the box of the Virtual remote enabled on the ProjectorView main screen, and click the VIRTUAL REMOTE button. The following Virtual Remote window appears.
For the functional descriptions of each button, see the user manual of the projector.
E-mail notification function
In case of an error or abnormality in the projector,
To use this function, perform the following steps.
1Enable the LAN control function. (See page 10.)
2Set the SMTP IP address,
Once the
Example of notification: Alert on lamp life end
ProjectorView Alert:
The lamp has reached its maximum usage. Replace the lamp and reset lamp counter. See user guide for complete instructions.
Projector name : abc
Projector model : HL650U
Projector location :
Serial number : 12345
Operating hours : 2146 hours and 43 minutes
Lamp hours : 5000 hours and 0 minute
Installation date: 2007/01/01
Last lamp replacement date: 2007/01/01
Last maintenance date: 2007/01/01
(Note)
•In case of a command error,
•When the LAN control is enabled, serial
•You can’t control the LAN/serial
•When commands for LAN control and for
•While a test pattern is displayed or a password is entered, you can’t change the lamp mode and enable and disable the MUTE function.
•Response may be delayed depending on the operating state of the projector.
•The DHCP mode may not operate with certain devices (routers etc.).
•When you turn on the projector by pressing the ON/OFF button on the ProjectorView main screen, other commands are not accepted for about 1 minute.
•
To use the