Mitsubishi Electronics PAC-YG63MCA instruction manual Wiring Instructions 7-1. Terminal Diagram

(3)Refer to "7. Wiring Instructions" and connect the wires for the power line, M-NET transmission line, output signal lines, and sensor input signal lines.

M-NET Sensor input signal lines	Output	Power line
	signal lines

AI

controller

Relay

Junction	24 VDC
terminal
block	Power
	source

PAC-SC50KUA

M-NET

Note:

•Do not install the sensor input signal lines parallel to or near the M-NET transmission line or power line. Also avoid loop wiring.

•Be sure to ground this device, PAC- SC50KUA and 24 VDC Power source. Measurement accuracy may be affected if devices are not grounded.

Caution:

• Perform wiring so that the terminal

block is not strained.

If strained, use a wire guide or

junction terminal to alleviate the

stress on the terminal block.

• Do not connect the wires directly from

the top of the control panel to the

terminal block.

Moisture may enter this device along

the wiring and cause electric shock or

fire.

Diagram Image (Installed within a Control Panel)

* The wiring in the diagram has been simplified.

7Wiring Instructions 7-1. Terminal Diagram

				Non-voltage Contact
LED17	Function			Output
	Settings
M-NET	SW01	SW02	SW03	SW08 SW09
power on
	Output	LED03	/ 02	CN03
	LEDs

Status LEDs					M-NET	10s	1s
					Address
		LED11/ 12/ 13/ 14/ 15/ 16	(CPU power on)
						SW06	SW07
M-NET		Analog Input		SW11		SW12
		Setting
A / B /	S						24 VDC Power Supply
		CN02					V+ / V- / FG
							CN01
		CN10		CN05		CN08
		Channel 1		Channel 1		Channel 2
		Pt100 Input	Analog Input			Analog Input

6