MODELS:
DIAMOND SHIELD REPLACEMENT
(WD-62927 / WD-73927 Only)
To Remove the Diamond Shield:
1)While wearing soft cotton gloves, loosen the sides of the Diamond Shield by pressing a small plastic card (the size of a standard credit card or a clean, plastic, putty knife) into the middle of the side slot. The Diamond Shield side will snap out of the top, middle and bottom clips. Loosen both sides before proceeding to step 2.
2)After the sides are free, gently push down on the top of the Diamond Shield. It will slide out of the top channel.
3)Carefully pull the screen up to it from the bottom channel. Store the Diamond Shield in a clean dust free area, where it will not be scratched.
To Install the Diamond Shield:
4)Slide the Diamond Shield into the bottom channel, making sure it fits securely.
5)Press gently on the top of the Diamond Shield to slightly bow the screen toward you. Insert the top of the Diamond Shield into the top channel. It should fit securely.
6)At each side, gently press the top, middel and bottom of the Diamond Shield to snap it back into place.
WARNING
Sharp edges! Always wear gloves to handle, lift, install and remove the Diamond Shield.
Page 38
