MODELS:
3. Adjustment Selection
Use the “VIDEO” button to select a specific electrical ajustment, “1 HPOS” or “2 VPOS”.
4. Adjusting Data
After selecting an adjustment item, use the “UP” and “DN” buttons to change adjustment data.
ªIf the “UP” button is pressed, the adjustment data increases.
ªIf the “DN” button is pressed, the adjustment data decreases.
5.Saving data
Press “ENTER” to save the adjustment data in memory.
The display characters go red for approx. one second in this step.
Note: If the circuit adjustment mode is terminated without pressing “ENTER”, changes in adjustment data are not saved.
6. Terminating the circuit adjustment mode
Press the “MENU” button on the remote hand unit twice to terminate the adjustment mode.
Note: The adjustment mode can be also terminated by turning the power off.
Resetting Data to Factory Values
1)Enter the Service Adjustment Mode ... Press
2)Press “0” when in the Service Mode ... Four choices appear at the top of the screen.
Data Transfer | |
Display | Description |
Copy Engine E2PROM to DM | Transfers Engine data to DM E2PROM |
Restore Backup | Restores data to factory values |
UPLOAD TERMINAL BOARD DATA | DO NOT USE |
Download WB Alignment to FMT | Transfers Engine data to FMT |
3) User UP & DN keys to highlight the desired choice, the Press “ENTER”
Page 45
