Remote Control Functions:Operation, Care, Sleep Timer
CABLE/DBS/DTV VCR DVD
TV AUDIO
2
1
1 2 3
4 5 6
3POWER
Care
For Best Results from the Remote Control:
7 | 8 | 9 |
|
|
|
| SUB/CANCEL |
4 SQV | 0 | 5 QV | 6 |
7 | 8 | 9 | 10 |
|
|
| |
DEVICE | CH | VOL | MUTE |
TV MENU | 12 | GUIDE | 15 |
| |||
11 |
| 14 |
|
DEVICE | 13 |
|
|
MENU | HOME |
| |
16 |
| 17 |
|
1819 20 21
PIP CH PIP/POP | EXCH | SLEEP | |
22 | 23 | 24 | 25 |
PIP DEVICE | FORMAT | CONNECT | |
| 26 | 27 | 28 |
29 | REC | PAUSE 30 |
31 REW/REV | 32 PLAY | 34 | |
33 | FF/FWD | ||
| STOP |
|
Figure 1. Remote Control Overview
Operation
Figure 2
Installing the Batteries:
1.Remove the remote control’s back cover by gently pressing the ribbed tab in the direction of the arrow and sliding off the cover.
2.Load two AA batteries, making sure the polarities (+) and
AA (alkaline) batteries
AA | AA |
Figure 2. Operation: Installing the Batteries
•Be within 20 feet of the equipment.
•Do not press two or more buttons at the same time unless instructed to do so.
•Do not allow unit to get wet or become heated.
•Avoid dropping on hard surfaces.
•Do not use harsh chemicals to clean. Use only a soft, lightly moistened cloth.
•Do not mix new and old batteries.
•Do not heat, take apart or throw batteries into fire.
•Use only AA alkaline batteries.
Hint: If the remote is in the TV layer and will not function, press POWER and 000 (or POWER and 935 if NetCommand® is setup) to reset the remote.
Sleep Timer
Setting the Sleep Timer:
1.Press SLEEP on the remote control.
2.Each press of SLEEP increases the time displayed by 30 minutes, until the maximum value of 120 minutes is reached.
3.After 5 seconds of inactivity, the message will disappear.
4.Press SLEEP to view the remaining time before the timer turns the TV off.
Canceling the Sleep Timer:
1.Press SLEEP to display the
2.Press SLEEP repeatedly until OFF is displayed.
Note: After 5 seconds of inactivity, the message box disappears.
31