
Installation
11. Remove the inner glass |
| |
latching studs and fit to |
| |
opposite side of door using |
| |
Loctite 243 to secure. |
| |
12. Turn the door handle over |
| |
Remove Latching Studs | ||
and fit to the other end of | ||
| ||
the door where the hinges |
| |
were removed from. Ensure |
| |
Flat of handle is to the |
| |
outside. |
|
Remove the Upper and Lower Door Hinges and Door Catch.
16.Remove the Blanking Screw and Door Catch from the front of the oven and swap around.
Door Catch | Blanking Screw |
|
17.Fit the door spacers removed at Item 13 opposite to the lower hinge pivot bolt.
Oven Door Re-Fitting
13.Remove the bottom door pivot bolt and spacers and fit the pivot bolt to the top door hinge assembly (as this will be swapped over and fitted to the bottom of the other side of the oven).
14.Remove the 4 blanking screws from the front of the oven.
Bottom Door Pivot Bolt and Spacers.
Fit the Door.
1. Refit the oven door by Top Door Pivot Bolt. locating the bottom of the
door onto the bottom hinge plate pivot bolt and spacers.
2.Fit the top of the door into the top hinge plate and secure with the top pivot bolt.
Fit Inner Glass to Door.
Remove screws top and bottom and fit to where hinges removed from.
15.Remove the Hinge Plate from the top of the oven and fit diagonally opposite, to the lower corner.
Remove these screws to remove
top and bottom hinges.
16.Remove the Hinge Plate from the bottom of the oven and fit diagonally opposite, to the upper corner.
17.Fit the screws removed at Item 14 above to where the hinges were fitted.
NOTE: It is important to ensure that the inner glass is fitted correctly and that the glass pivots at the hinge end of the door and not the handle end.
3.Fit the pivot spacer removed at Item 3 on the previous page, to the lower inner glass pivot and locate the inner glass lower pivot into position on the inside of the door.
4.Locate the top pivot of the inner glass into the top of the door and secure in position with the inner glass retaining clip.
|
| Screw and | |
|
| Retaining Clip. | |
5. Lift the inner glass up onto |
|
|
|
| |||
Inner Glass Locking Catch |
| ||
the locking catch to lock into |
|
|
|
|
|
| |
position. |
|
|
|
Adjust the Door for Correct Alignment.
Check the operation of the door. Ensure that the door roller catch correctly retains the door in the closed position.
To adjust, slightly loosen the screws securing the roller catch and close the door. The roller catch will centralise itself. Open the door and tighten the roller catch securing screws.
6