Installation
Electrical Connection
Warning
This oven must be earthed / grounded.
If the supply cord is damaged, it must be replaced by a suitably qualified person in order to avoid a hazard.
Reversing the Oven Door
NOTE: This operation should only be carried out by a suitably competent person.
Remove the Oven Door Inner Glass.
Each oven should be connected to an adequately protected power supply and an isolation switch mounted adjacent to, but not behind the oven and must be readily accessible to the operator. This switch must be clearly marked and readily accessible in case of fire.
Check the electricity supply is correct to as shown on the Technical Data Plate on the front right hand corner of the oven side panel.
Ensure that the oven is fitted with the appropriate power cord and plug.
Positioning and Levelling of Oven
1.Correctly locate the oven into its final operating position and using a spirit level, adjust the oven feet so that the oven is level and at the correct height.
Initial Start-Up
1.Open the oven door and open the door inner glass.
2.Remove the screw securing the inner glass retaining clip and remove the clip.
3.Lift up the inner glass and remove, ensuring that the pivot spacer is removed from the lower inner glass pivot and retained.
4.Remove the black plastic plugs from the top and bottom of the door and fit to the holes where the inner glass pivots were removed from.
Remove the Oven Door.
Remove Screw and
Retaining Clip.
Fit Blanking Plugs.
Before using the new oven;
1.For first time use of the oven, operate the oven for about 1 hour at 200°C / 400°F to remove any fumes or odours which may be present.
2.Please refer to the Operation Section of this manual for details on how to correctly operate and shutdown the oven.
Commissioning
5.Remove the door roller catch and blanking plate from the inside of the door and swap these over.
Swap Roller Catch and
Blanking Plate over.
Before leaving the new installation;
Check the oven functions in accordance with the operating instructions specified in the ‘Operation’ section of this manual.
Ensure that the operator has been instructed in the areas of correct operation and shutdown procedure for the appliance.
NOTE: If for some reason it is not possible to get the appliance to operate correctly, turn off the power supply at the mains supply and contact the supplier of this appliance.
6.Whilst supporting the door, unscrew and remove the top door pivot bolt from the top door hinge assembly.
7.Remove the door and lay on a flat surface or workbench.
8.Unscrew the screws securing the door handle and remove the door handle.
Remove Top
Door Pivot Bolt.
Remove Handle
Securing Screws
9. Remove the top door hinge | Remove Top Door Hinge |
| |
and fit to the bottom |
|
opposite corner of the door. |
|
10.Remove the bottom door hinge and fit to the top opposite corner of the door.
5
