If you fit your own plug, the colours of the wires in the mains lead of your appliance, may not correspond with the markings identifying the terminals in your plug, proceed as follows:
Connect the Green and the Yellow (earth) wire to the terminal in the plug which is marked with
the letter «E» or the earth symbol 
, or coloured green and yellow.
Connect the blue (neutral) wire to the terminal in the plug which is marked with the letter «N» or coloured black.
Connect the brown (live) wire to the terminal in the plug which is marked with the letter «L» or coloured red.
The plug moulded onto the lead incorporates a fuse. For replacement, use a 13amp BS1362 fuse. Only ASTA or BSI approved fuses should be used.
The plug must not be used if the fuse cover/carrier is lost. The cover/carrier is indicated by the coloured insert at the base of the plug.
This appliance complies with the following E.E.C. Directive:
- 73/23 EEC of 19.2.73 (Low Voltage Directive) and subsequent amendments.
-87/308 of 2.6.87 (Radio Interference Suppression) and subsequent amendments.
-89/336 EEC of 3.5.89 (Electromagnetic Compatibility Directive) and subsequent amendments.
Please ensure that when the appliance is installed it is easily accessible for the engineer in the event of breakdown.
Installation
WARNING!
IF YOU ARE DISCARDING AN OLD APPLIANCE THAT HAS A LOCK OR CATCH ON THE DOOR, YOU MUST ENSURE THAT IT IS MADE UNUSABLE TO PREVENT YOUNG CHILDREN BEING TRAPPED INSIDE.
Depending upon the position which you choose for your appliance, you may wish to reverse the way in which the door opens. To do this, refer to instructions under “Door reversal”.
Important!
It must be possible to disconnect the appliance from the mains power supply; the plug must therefore be easily accessible after installation.
13
