Moffat MUL 514 user manual Something not working

Something not working

IMPORTANT!

Before contacting your local Service Force Centre check the following points.

IMPORTANT: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee.

Fault code / malfunction	Solution
Check there is power at the socket.
	No power to appliance
	Check there is not a power cut by checking the household lights.
	Check the fuse has not blown.
The light does not come on	Ensure that the bulb is correctly fitted.
	Replace the bulb if it has blown.
	Check the door light switch is not jammed.
The temperature in the fridge or	Check the ambient temperature is within the appliances
freezer section is too high	operating limits of 10°C to 38°C.
	Check the thermostat control knob is turned to the correct setting
	relative to ambient conditions.
The compressor runs	Adjust the thermostat control knob to give correct
continuously	temperature control. See page 5.
	Check that the door is closed.
	Large quantities of food have recently been placed in
	the cabinet and/or door is frequently opened.
	Check that air ventilation is not obstructed.
Excessive frost and ice has built	Ensure the door is not left open.
up.	Check that nothing is preventing the door from closing. Is the
	door gasket intact and clean?
Noise	Refer to normal operating sounds.
Water under the salad bins	Check the drain hole is not blocked.
	(see Maintenance and Cleaning).

If after the above checks, there is still a fault, call your local Service Force Centre.

In-guarantee customers should ensure that the above checks have been made as the engineer will make a charge if the fault is not a mechanical or electrical breakdown.

Please note that proof of purchase is required for any in-guarantee service calls.

IMPORTANT!

When carrying out the suggested corrective actions the appliance must be switched off.

9