624WBPF Woodburning Fireplace | CHIMNEY OFFSET INSTALLATION | |
|
|
|
Offset Installation Sequence
1.Determine the location and amount of offset required, then select the combinations of chimney sections and elbows required from the offset chart. Refer to Page 15.
2.Install the first elbow by placing the extended flue into the mating part of the fireplace or chimney sec- tion. Push down until the outside or inlet air duct of the elbow overlaps and the snaps lock the elbow into the fireplace or chimney section.
3.Nail the support straps to the framing member with a minimum of two
4.Install the sections of pipe between elbows until the proper number of chimney sections have been in- stalled.
5.Install the second elbow to return the run of the chimney to vertical.
6.Nail the support straps of the second elbow to a building frame member.
7.Continue installing the vertical portion of the chimney.
NOTE: If the inclined portion of the chimney passes through a floor or ceiling, a firestop spacer should be installed to provide the firestop and support required. Be sure proper spacing in maintained between the chimney and combustibles.
| Continue chimney to proper |
|
|
Figure 15 | height and install round chim- | C | Continue chimney through roof |
ney cap or chimney housing | L | ||
| Figure 16 | and install round chimney cap | |
|
| ||
|
|
| or chimney housing |
Storm | 3’ |
| Firestop Spacer 2” Minimum |
Min. |
| Air Space Clearance at Joist | |
Collar |
| ||
|
|
| |
|
| Support Straps | Chimney Must Be Enclosed |
Flashing | Attic | Not to Penetrate | in Accessible Areas |
Space | Firestop |
| |
|
| ||
| Refer to Table 1 | Vertical |
|
| Chimney | Vertical Chimney | |
| for Roof Opening | ||
Roof | Size | Enclosure | Enclosure |
| 17” x 17” Opening |
|
|
|
| Fasten All Support | Firestop Spacer |
|
| Straps Securely | |
|
|
| |
|
| Vertical Chimney Enclo- |
|
|
| sure Recommended. | Diagonal |
|
| Diagonal Chimney En- | Chimney |
2” Min. Air Space |
| closure Acceptable | Enclosure |
|
|
| |
Clearance to |
|
| RISE |
Combustibles |
| Diagonal Chimney | |
Fasten Support |
| ||
|
| ||
| Enclosure |
| |
| Straps Securely |
| |
|
|
|
30° Elbows | Support Straps |
|
| Offset Max 10’ |
|
| C | Firestop |
| Spacer 2” Air | |
| L | |
| NOTE: Four (4) elbows may be | Space Clear- |
| used when total installation height | ance to Com- |
| exceeds 24 ft. | bustibles |
Maximum four (4) elbows per
Fireplace
FP2353 | FP2354 |
|
14 | 53D9052 |