Monessen Hearth CFX24, CFX32 manual Install Mantel

CFX Vent Free Fireplace System INSTALL MANTEL

1.Place base near final position. Make sure you have access to all four (4) sides.

2.Place sides in the approximate location on base. Align back edge of side with back of base. Secure joining block #1 to bottom of side using two (2) 1Z\v” screws. Be sure joining block is flush with bottom of side piece. (Do not attach to base at this time)

3.With the aid of an assistant, and using two (2) joining block #4 and (12) 1Z\v” screws, secure header to the sides. Carefully match the moulding.

4.Adjust cabinet assembly so it is centered from side to side and the back of the sides are aligned with the back of the base.

5.Temporarily place top on side/header assembly. Adjust sides parallel to the base and top side. Secure the sides to the base using two (2) 1Z\v” screws in each of the joining blocks.

6. Once the mantel is assem-	Top	Joining Block #4	Joining
bled, temporarily place the		Header
			Block #4
fireplace into the mantel in or-
der to locate the trim pieces.

7. Center the fireplace in the opening with the inside of the fireplace trim or facing even with the inside of the front of the mantel.

8. Attach	the	horizontal		trim			Horizontal Trim
piece to the mantel header.
						Joining	Joining
Make	sure	the	horizontal		Right		Block #3
trim is	centered and there					Block #3
					Side
is an approximate 1/4” gap						Vertical
between the		bottom of		the		Trim		Left Side
horizontal trim and the top of
							Vertical Trim
the fireplace. Secure with two
					Joining
(2) screws; one on each end					Block #1		Joining
of the trim piece in the pre-						Joining
drilled holes.						Block #2	Block #2
9. Place the vertical trim pieces
so the edge is about 1/4” from
the fireplace body. Make sure
the joint between			the	trim			Joining	KT1220
pieces is satisfactory. Secure					Figure 7 -
						Base	Block #1
through joining block #3 into					Barrington Mantel

horizontal trim using two (2)

screws. Attach joining block #2 to the bottom of the vertical trim. Repeat for other side.

10.Remove fireplace and move mantel to its final position. Cut wall base moulding as necessary to provide adequate fit against wall.

11.Locate (anti-tip) bracket on wall so the cleat on the underside of the mantel top is captured in the wall bracket and the wall bracket is screwed into a stud.

Figure 8 -

Wall Bracket

12 20301726