GETTING STARTED
GETTING STARTED
Make sure you have received all parts:
Check your packing list to verify that all listed parts have been received. You should have the following:
•Unvented gas heater
•Two (2)
•Facing
•Installation/operating instructions
•Two (2) anchoring screws
•Cabinet
•Ceramic fiber logs
•Four (4) black screws
Millivolt controlled heater designed to be operated with optional devices for ON/OFF functions.
• Hand held Remote with receiver
• Wall
• Wall switch with 20' wire
• Hand held Thermostat Remote
| CAUTION | • Gloves are recommended when handling |
| ceramic fiber logs to prevent skin irritation | |
|
| |
|
| from loose fibers. Logs are fragile — |
|
| handle with care. |
|
|
|
Carefully inspect the contents for shipping damage. If any parts are missing or damaged, immediately inform the dealer from whom you purchased the appliance. Do not attempt to install any part of the appliance unless you have all parts in good condition.
What you will need for installation:
You must have the following items available before pro- ceeding with installation:
•External regulator (for propane/LPG only)
•Piping which complies with local codes
•Phillips head screwdriver
•Pipe sealant approved for use with propane/LPG (Resistant to sulfur compounds)
•Pipe wrench
CFX Vent Free Fireplace System
| WARNING | Do not install the heater: |
| • Where curtains, furniture, clothing, or | |
|
| |
|
| other flammable objects are less than |
|
| 42" from the front of the heater. |
|
| • In high traffic areas. |
|
| • In windy or drafty areas. |
|
|
|
In planning the installation for the fireplace it is necessary to determine where the unit is to be installed and whether optional accessories are desired. Gas supply piping should also be planned. The following steps represent the normal sequence of installation. Each installation is unique, how- ever, and might require a different sequence.
1.Determine desired location for fireplace. Refer to the Location of Fireplace and Clearances and Height Requirements sections in this manual.
NOTE: Be sure all packing material has been removed from underside the unit.
2.Assemble mantel and install fireplace according to the instructions in this manual.
2.Install logs per instructions found in this manual.
3.Field wire main power supply to units with fan kit. Refer to the Electrical Section found in this manual. (Electrical connections should only be performed by an experi- enced, licensed certified tradesman).
4.Install optional ON/OFF kit on units with millivolt control. Refer to the installation instructions included with the kit and also refer to the Electrical Wiring section found in this manual.
5.Plumb gas line according to the Connecting the Gas section found in this manual. (Gas connections should only be performed by an experienced,
licensed/certified tradesman).
20301726
