INSTALLATION
Damper stop installation:
A damper stop must be provided with the unit. Contact your dealer to obtain one. The damper stop must be installed as shown in Figure 11 to prevent full closure of the fireplace damper blade and provide a minimum 29 square inch flue opening.
Damper
Stop
Damper |
|
|
|
|
|
|
|
|
|
|
| Figure 11 - | |
|
|
|
|
|
|
|
|
|
|
| ||
FP2538 |
|
|
|
|
|
|
|
|
| Damper Stop Installation | ||
|
| |||||||||||
| The fireplace and gas logs function as a | |||||||||||
WARNING | system. If the fireplace is spilling into the | |||||||||||
room (check with a match or a smoke stick), | ||||||||||||
|
EYF Series Unvented Gas Log Set
| You must secure the gas log heater to the |
| fireplace floor. If not, the entire unit may move |
| when you adjust the controls. Movement of |
| unit may cause shifting of the gas logs which |
WARNING | leads to sooting and improper burning. |
gas log controls. This will insure adequate | |
| Special care is required if you are installing |
| the unit into a sunken fireplace. You must |
| raise the fireplace floor to allow access to |
| air flow and guard against sooting. Raise |
| the fireplace floor using noncombustible |
| materials, as described in Placement in |
| a Fireplace with Restrictive Barrier on |
| Page 10. |
|
|
Hole for | Screws | |
Grate Bar | ||
| ||
Horizontal |
| |
Grate Bar |
|
reposition the damper clamp until a positive draft is obtained by opening the damper. If negative pressure in home prevents having a positive draft, contact your dealer for assistance.
PLACE and SECURE APPLIANCE
Hook for
Grate
Middle Grate Bar
Hook for Grate
HI
OFF
FP2539
Assembly procedure:
Figure 12
1.Center the gas log unit in the fireplace or firebox.
2.Install Grate: Insert longest middle grate bar in one of the two square holes in control panel. Be sure grate is centered. Sit horizontal bar inside two (2) hooks on front of control panel. Make certain front feet of grate are located inside front edge of fireplace or firebox.
3.Anchor holes are located on the flange of the unit. After centering the burner correctly, mark the hole positions on the fireplace/firebox floor. Drill two (2) 5/32" diameter holes approximately 1Z\x" deep.
4.Anchor the unit to the fireplace/firebox floor using the
screws provided.
Figure 12 -
Install Grate and Secure Heater to Floor of Fireplace/Firebox
65D1009 | 11 |