Montgomery Ward TMO-39083A manual Necessary to loosen the cable brackets which are mounted to

FIGURE 7.

FIGURE 8.

IAI13.

Mount the handle panel (AC) to the handles. Secure with carriage bolts (M), lock washers

-(N) and hex nuts (0). See figure 7.

NOTE

To align the holes in the handle panel and the handle, it may be

necessary to loosen the cable brackets which are mounted to the

back of the handles with self- tapping screws.

THROTTLE CONTROL INSTAllATION

Assemble the throttle control to the handle panel as follows.

1.Hold the throttle control assembly beneath the handle panel. Turn the control sideways and insert the lever up through the wide por- tion of the slot on the handle panel. See figure 8A.

2.After the end of the lever is through the slot,

	turn and then tip the control forward as shown
-in	figure 88 to slide it through the slot.

NOTE

The lever must be all the way to the back of the control housing as shown in figure 88.

3.Push the control back into the slot in the han- dle panel and press in place. Be certain the control is locked securely into the slot.

ATTACHING THE TINE CLUTCH CONTROL CABLE The clutch control cables are already attached to the unit. The tine clutch control cable has a "Z" fitting on the loose end. This cable attaches to the

left handle.

NOTE

Both the drive clutch cables and the

tine clutch cable are attached tosprings, which are hooked to bolts.

If either the cable or spring has

come loose in shipping, it must bereassembled. Refer to page 18, ref-

erence numbers 2, 5,11,12,15,17

and 21.

Remove one nut and the lock washer from the end of the tine clutch cable (short cable). Slip the cable up through the slot on the cable bracket on the left handle. Rethread hex nut

and lock washer on the end of the cable. See-figure 9. Do not tighten at this time.

6