Settings menu | Motorola D200 instruction

Allegro_CID.book Page 14 Tuesday, January 15, 2008 3:07 PM

English

Call barring

When switched on, Call Barring prevents calls being made.

1.Press to access the main menu.

2.Press or to select "HS SETTINGS". Press .

3.Press or to select "BARRING". Press .

4."PIN ?" is displayed. Enter the PIN code using the number

keypad. Press .

5.Press or to select "ON" or "OFF". Press to confirm.

9. Settings menu

Tones

You can switch on or off the tones for key touch, battery low, and out-of-range alarm.

For example, when the key tone is set to ON, you will hear a tone each time you press a keypad button.

1.Press to access the main menu.

2.Press or to select "HS SETTINGS". Press .

3.Press or to select "TONE SETUP". Press .

4.Press or to select the option you want

"KEY TONE"

"BATTERY LOW" "RANGE ALARM"

Press .

5.Press or to display either "ON" or "OFF". Press to confirm.

Flash

Recall is used when connected to certain switchboards, for transferring calls to another extension number, and for some network services. Contact your network or switchboard

provider for advice on how to use the (flash) button.

Changing the flash time

You can select the flash time from short or long according to your switchboard requirements.

Consult your switchboard provider for advice if unsure which setting you need.

1.Press to access the main menu.

2.Press or until "BS SETTINGS" is displayed and press .

3.Press or to select "FLASH TIME" and press .

4.Press or to select "SHORT" or "LONG" and press .

Dial mode

You can set your phone to use either Tone or Pulse dialling. The pre-set setting is TONE dialling, where you will hear a tone beep each time you dial a number.

Most modern exchanges and switchboards use Tone dialling, so you should not need to change this setting. Only change it if your switchboard uses Pulse dialling or if you cannot make a call using Tone dialling.

1.Press to access the main menu.