-15-
W1747 20" Planer
SET UP
Before starting your machine for the first time, make
sure the gearbox has oil. The proper oil level is just even
with the bottom of the fill plug hole. The gearbox uses
80W-90W automotive grade gear oil.
To check the gearbox oil level, do these steps:
1. Wipe the outside of the fill plug clean.
2. Using a 14mm wrench or socket, remove the gear-
box fill plug (Figure 8).
3. Using the short end of a CLEAN 6mm hex wrench,
dip it inside the fill hole and remove it. (Do not drop
the wrench into the gearbox!)
— If the end of the hex wrench is coated with oil,
then the gearbox oil level is okay. Replace the fill
plug and continue with set up.
— If the end of the hex wrench is not coated with
oil, then fill the gearbox with 80-90W gear oil
until the oil reaches the top of the fill plug.
Note: Replace the gearbox oil after the first 20
hours of operation. This is a normal break-in pro-
cedure.
Gearbox Oil Level
Figure 8. Gearbox fill plug location.
Connecting to Power
Now is the time to connect your planer to the power
source. Make sure you have read and followed precautions
listed on Page 9, before doing so.
Knife Setting Gauge
Assemble the knife setting gauge as shown in Figure 9.
Figure 9. Knife setting gauge assembled.