Manuals / Woodstock / Power Tools / Planer

Woodstock W1747 owner manual Handwheel, Dust Hood, To install the handwheel, do these steps

Models: W1747

1 56

Download 56 pages 31.64 Kb

Page 16

W1747 20" Planer

SET UP

Handwheel

To install the handwheel, do these steps:

1.Place the bushing on the handwheel shaft.

2.Insert the key into the shaft keyway.

3.Thread the handle into the handwheel.

4.Place the handwheel on the shaft and secure it with the M12-1.75 hex nut and flat washer, as shown in

Figure 6.

Dust Hood

During the next step, DO NOT attach the dust hood if you do not intend to connect your planer to a dust collection system. Accumulated wood chips could cause a malfunction, resulting in personal injury or damage to the planer.

To install the dust hood, do these steps:

1.Attach the dust hood to the planer with six M6-1 x 12 cap screws and flat washers as shown in Figure 7.

2.Attach the dust hood to the dust collector.

Note: To maximize work results and minimize clog- ging, chipout, etc., use a dust collector with your planer!� �

Figure 6. Installing handwheel on shaft.

Figure 7. Dust hood attached.

-14-

Image 16

Woodstock W1747 owner manual Handwheel, Dust Hood, To install the handwheel, do these steps

Contents

Planer Page Contents Service Introduction Woodstock Technical SupportSpecifications Controls and Features Safety Standard Safety InstructionsAlways Lock Mobile Bases if Used Before Operating Machinery Additional Safety Instructions for Planers Electrical 220V OperationExtension Cords GroundingSET UP Items Needed for Set UpUnpacking InventoryLifting Planer Machine PlacementHardware and Tools Cleaning Machine These items are coated and must be cleanedExtension Wings Extension wing fasteners Leveling controlsHandwheel To install the handwheel, do these stepsDust Hood Connecting to Power Knife Setting GaugeGearbox Oil Level To check the gearbox oil level, do these stepsRecommended Adjustments Test RunTighten V-Belts To perform a test run, do these stepsOperations GeneralBasic Operation Basic steps of operating the planer are as followsOperation Tips Feed Speed Feed control knob positionsTo adjust the bed rollers, do these steps Adjustment Height Range 002-0.020Bed Rollers Accessories Planer AccessoriesOFF Cleaning MaintenanceMaintenance Schedule To adjust/replace the V-belts, do these steps BeltsLubrication Inspecting Knives ServiceTo inspect the knives, do these steps Setting/Replacing Knives To set the knives, do these stepsTo adjust the chain tension, do these steps Chain TensionTable Parallelism Maximum Allowable TolerancesTo adjust the table parallelism, do these steps Table micro-adjustment screwsRollers, Chip Breaker Pressure Bar Heights Distance Below Knife Edge at *BDCRoller height adjustment 27, 28,Service To adjust roller spring tension, do these steps Spring TensionChip Deflector Gap Setting To adjust the deflector position, do these stepsScale Calibration To calibrate the scale, do these stepsAnti-Kickback Fingers Anti-kickback fingersPulley Alignment Checking belt alignmentW1747 Electrical Components W1747 motor junction boxW1747 Wiring Diagram Troubleshooting Moving parts have come to a complete stopCutting Headstock Assembly Parts Breakdown Headstock Assembly Parts List PART# DescriptionXPN09M Table, Base, and Columns Parts Breakdown Table, Base, and Columns Parts List Stand/Motor Assembly Parts Breakdown Stand/Motor Assembly Parts List Parts Warranty Warranty Registration CommentsBOX BELLINGHAM, WA