Service | Woodstock W1747 guide

SERVICE MAINTENANCE OPERATIONS SET UP ELECTRICAL SAFETY INTRODUCTION

PARTS

SERVICE	26
General	26
Inspecting Knives	26
Setting/Replacing Knives	27
Chain Tension	28
Table Parallelism	29
Rollers, Chip Breaker & Pressure Bar Heights	31
Spring Tension	34
Chip Deflector Positioning	35
Scale Calibration	35
Anti-Kickback Fingers	36
Pulley Alignment	37
W1747 Electrical Components	38
W1747 Wiring Diagram	39
Troubleshooting	40
Headstock Assembly Parts Breakdown	42
Headstock Assembly Parts List	43
Table, Base, and Columns Parts Breakdown	45
Table, Base, and Columns Parts List	46
Stand/Motor Assembly Parts Breakdown	47
Stand/Motor Assembly Parts List	48
Warning Label Placement and Parts List	49

USE THE QUICK GUIDE PAGE LABELS TO SEARCH OUT INFORMATION FAST!

Image 4

Woodstock W1747 owner manual Service

Contents

Planer Page Contents Service Introduction Woodstock Technical Support Specifications Controls and Features Safety Standard Safety Instructions Always Lock Mobile Bases if Used Before Operating Machinery Additional Safety Instructions for Planers Electrical 220V OperationExtension Cords Grounding SET UP Items Needed for Set UpUnpacking Inventory Lifting Planer Machine PlacementHardware and Tools Cleaning Machine These items are coated and must be cleaned Extension Wings Extension wing fasteners Leveling controls Handwheel To install the handwheel, do these stepsDust Hood Connecting to Power Knife Setting GaugeGearbox Oil Level To check the gearbox oil level, do these steps Recommended Adjustments Test RunTighten V-Belts To perform a test run, do these steps Operations GeneralBasic Operation Basic steps of operating the planer are as follows Operation Tips Feed Speed Feed control knob positions To adjust the bed rollers, do these steps Adjustment Height Range 002-0.020Bed Rollers Accessories Planer Accessories OFF Cleaning MaintenanceMaintenance Schedule To adjust/replace the V-belts, do these steps Belts Lubrication Inspecting Knives ServiceTo inspect the knives, do these steps Setting/Replacing Knives To set the knives, do these steps To adjust the chain tension, do these steps Chain Tension Table Parallelism Maximum Allowable Tolerances To adjust the table parallelism, do these steps Table micro-adjustment screws Rollers, Chip Breaker Pressure Bar Heights Distance Below Knife Edge at *BDC Roller height adjustment 27, 28, Service To adjust roller spring tension, do these steps Spring Tension Chip Deflector Gap Setting To adjust the deflector position, do these stepsScale Calibration To calibrate the scale, do these steps Anti-Kickback Fingers Anti-kickback fingers Pulley Alignment Checking belt alignment W1747 Electrical Components W1747 motor junction box W1747 Wiring Diagram Troubleshooting Moving parts have come to a complete stop Cutting Headstock Assembly Parts Breakdown Headstock Assembly Parts List PART# Description XPN09M Table, Base, and Columns Parts Breakdown Table, Base, and Columns Parts List Stand/Motor Assembly Parts Breakdown Stand/Motor Assembly Parts List Parts Warranty Warranty Registration Comments BOX BELLINGHAM, WA