Contents | Woodstock W1747 specs

Contents
INTRODUCTION	3
Woodstock Technical Support	3
Specifications	4
Controls and Features	5
SAFETY	6
Standard Safety Instructions	6
Additional Safety Instructions for Planers	8
ELECTRICAL	9
220V Operation	9
Extension Cords	9
Grounding	9
SET UP	10
Unpacking	10
Items Needed for Set Up	10
Inventory	10
Machine Placement	11
Lifting Planer	11
Cleaning Machine	12
Extension Wings	13
Handwheel	14
Dust Hood	14
Gearbox Oil Level	15
Connecting to Power	15
Knife Setting Gauge	15
Test Run	16
Tighten V-Belts	16
Recommended Adjustments	16
OPERATIONS	17
General	17
Basic Operation	17
Operation Tips	18
Feed Speed	19
Bed Rollers	20
ACCESSORIES	21
Planer Accessories	21
MAINTENANCE	23
General	23
Cleaning	23
Maintenance Schedule	23
V-Belts	24
Lubrication	25

INTRODUCTION SAFETY ELECTRICAL

SET UP OPERATIONS MAINTENANCE SERVICE

USE THE QUICK GUIDE PAGE LABELS TO SEARCH OUT INFORMATION FAST!

PARTS

Image 3

Woodstock W1747 owner manual Contents

Contents

Planer Page Contents Service Woodstock Technical Support Introduction Specifications Controls and Features Standard Safety Instructions Safety Always Lock Mobile Bases if Used Before Operating Machinery Additional Safety Instructions for Planers Grounding Electrical220V Operation Extension Cords Inventory SET UPItems Needed for Set Up Unpacking Machine Placement Lifting PlanerHardware and Tools These items are coated and must be cleaned Cleaning Machine Extension wing fasteners Leveling controls Extension Wings To install the handwheel, do these steps HandwheelDust Hood To check the gearbox oil level, do these steps Connecting to PowerKnife Setting Gauge Gearbox Oil Level To perform a test run, do these steps Recommended AdjustmentsTest Run Tighten V-Belts Basic steps of operating the planer are as follows OperationsGeneral Basic Operation Operation Tips Feed control knob positions Feed Speed Adjustment Height Range 002-0.020 To adjust the bed rollers, do these stepsBed Rollers Planer Accessories Accessories OFF Maintenance CleaningMaintenance Schedule Belts To adjust/replace the V-belts, do these steps Lubrication Service Inspecting KnivesTo inspect the knives, do these steps To set the knives, do these steps Setting/Replacing Knives Chain Tension To adjust the chain tension, do these steps Maximum Allowable Tolerances Table Parallelism Table micro-adjustment screws To adjust the table parallelism, do these steps Distance Below Knife Edge at *BDC Rollers, Chip Breaker Pressure Bar Heights 27, 28, Roller height adjustment Service Spring Tension To adjust roller spring tension, do these steps To calibrate the scale, do these steps Chip Deflector Gap SettingTo adjust the deflector position, do these steps Scale Calibration Anti-kickback fingers Anti-Kickback Fingers Checking belt alignment Pulley Alignment W1747 motor junction box W1747 Electrical Components W1747 Wiring Diagram Moving parts have come to a complete stop Troubleshooting Cutting Headstock Assembly Parts Breakdown PART# Description Headstock Assembly Parts List XPN09M Table, Base, and Columns Parts Breakdown Table, Base, and Columns Parts List Stand/Motor Assembly Parts Breakdown Stand/Motor Assembly Parts List Parts Warranty Comments Warranty Registration BOX BELLINGHAM, WA