Controls and Features | Woodstock W1747 specification

W1747 20" Planer

Controls and Features

INTRODUCTION

A

I

B

C

D

E F

G H

G

J

K

L

Figure 1. W1747 Controls and features.

A.Control Box and Panel

B.Return Rollers

C.Table Height Handwheel

D.Gearbox

E.Speed Control Knob

F.Table Height Scale

G.Table Locks

H.Lifting Bar

I.Extension Wing

J.Dust Hood

K.V-Belt Cover

L.Motor and Magnetic Switch Access Panel

-5-

Image 7

Woodstock W1747 owner manual Controls and Features

Contents

Planer Page Contents Service Woodstock Technical Support Introduction Specifications Controls and Features Standard Safety Instructions Safety Always Lock Mobile Bases if Used Before Operating Machinery Additional Safety Instructions for Planers Grounding Electrical220V Operation Extension Cords Inventory SET UPItems Needed for Set Up Unpacking Lifting Planer Machine PlacementHardware and Tools These items are coated and must be cleaned Cleaning Machine Extension wing fasteners Leveling controls Extension Wings Handwheel To install the handwheel, do these stepsDust Hood To check the gearbox oil level, do these steps Connecting to PowerKnife Setting Gauge Gearbox Oil Level To perform a test run, do these steps Recommended AdjustmentsTest Run Tighten V-Belts Basic steps of operating the planer are as follows OperationsGeneral Basic Operation Operation Tips Feed control knob positions Feed Speed To adjust the bed rollers, do these steps Adjustment Height Range 002-0.020Bed Rollers Planer Accessories Accessories OFF Cleaning MaintenanceMaintenance Schedule Belts To adjust/replace the V-belts, do these steps Lubrication Inspecting Knives ServiceTo inspect the knives, do these steps To set the knives, do these steps Setting/Replacing Knives Chain Tension To adjust the chain tension, do these steps Maximum Allowable Tolerances Table Parallelism Table micro-adjustment screws To adjust the table parallelism, do these steps Distance Below Knife Edge at *BDC Rollers, Chip Breaker Pressure Bar Heights 27, 28, Roller height adjustment Service Spring Tension To adjust roller spring tension, do these steps To calibrate the scale, do these steps Chip Deflector Gap SettingTo adjust the deflector position, do these steps Scale Calibration Anti-kickback fingers Anti-Kickback Fingers Checking belt alignment Pulley Alignment W1747 motor junction box W1747 Electrical Components W1747 Wiring Diagram Moving parts have come to a complete stop Troubleshooting Cutting Headstock Assembly Parts Breakdown PART# Description Headstock Assembly Parts List XPN09M Table, Base, and Columns Parts Breakdown Table, Base, and Columns Parts List Stand/Motor Assembly Parts Breakdown Stand/Motor Assembly Parts List Parts Warranty Comments Warranty Registration BOX BELLINGHAM, WA