Table, Base, and Columns Parts Breakdown | Woodstock W1747 specification

W1747 20" Planer

Table, Base, and Columns Parts Breakdown

		��
		��
		��
		��
		��
		��
��			��
��			��
��
	��
	��
��
��		��
		��
			��
			��
			��
			��
			��
��			��
��		��	��
		��	��
��		��	��
			��
			��
��		��	��
��		��	��
��			��
��		��
��
��		��
		��
��		��
��		��
��
��	��	��
��	��	��
��	��	��
��	��
��		��
��
��

��

��

��

��

��

��

��

��

��

��

��

��

PARTS

-45-

Image 47

Woodstock W1747 owner manual Table, Base, and Columns Parts Breakdown

Contents

Planer Page Contents Service Woodstock Technical Support Introduction Specifications Controls and Features Standard Safety Instructions Safety Always Lock Mobile Bases if Used Before Operating Machinery Additional Safety Instructions for Planers Grounding Electrical220V Operation Extension Cords Inventory SET UPItems Needed for Set Up Unpacking Hardware and Tools Machine PlacementLifting Planer These items are coated and must be cleaned Cleaning Machine Extension wing fasteners Leveling controls Extension Wings Dust Hood To install the handwheel, do these stepsHandwheel To check the gearbox oil level, do these steps Connecting to PowerKnife Setting Gauge Gearbox Oil Level To perform a test run, do these steps Recommended AdjustmentsTest Run Tighten V-Belts Basic steps of operating the planer are as follows OperationsGeneral Basic Operation Operation Tips Feed control knob positions Feed Speed Bed Rollers Adjustment Height Range 002-0.020To adjust the bed rollers, do these steps Planer Accessories Accessories OFF Maintenance Schedule MaintenanceCleaning Belts To adjust/replace the V-belts, do these steps Lubrication To inspect the knives, do these steps ServiceInspecting Knives To set the knives, do these steps Setting/Replacing Knives Chain Tension To adjust the chain tension, do these steps Maximum Allowable Tolerances Table Parallelism Table micro-adjustment screws To adjust the table parallelism, do these steps Distance Below Knife Edge at *BDC Rollers, Chip Breaker Pressure Bar Heights 27, 28, Roller height adjustment Service Spring Tension To adjust roller spring tension, do these steps To calibrate the scale, do these steps Chip Deflector Gap SettingTo adjust the deflector position, do these steps Scale Calibration Anti-kickback fingers Anti-Kickback Fingers Checking belt alignment Pulley Alignment W1747 motor junction box W1747 Electrical Components W1747 Wiring Diagram Moving parts have come to a complete stop Troubleshooting Cutting Headstock Assembly Parts Breakdown PART# Description Headstock Assembly Parts List XPN09M Table, Base, and Columns Parts Breakdown Table, Base, and Columns Parts List Stand/Motor Assembly Parts Breakdown Stand/Motor Assembly Parts List Parts Warranty Comments Warranty Registration BOX BELLINGHAM, WA