Pelco CM9700UTP32A manual Cable Maximum Distance Type Video only, Wire Gauge minimum allowable

You can connect the active receiver to a transmitter such as the TW4001P passive transceiver, TW3001AT active transmitter, and CC3710/ CC3610 UTP cameras. The receiver also has video ribbon cable connectors for connecting to a CM9700 Series matrix. Connect these products using UTP Cat5e and Cat6 cable for best video performance.

Table B shows the maximum cable distance for video when connecting an active receiver to a TW4001P passive transceiver.

Table B. Cable Distance with TW4001P

Cable	Maximum Distance
Type	(video only)
Cat5	3,000 ft (914 m)
Cat5e	4,000 ft (1,219 m)
Cat6	4,000 ft (1,219 m)

Table C shows the minimum wire gauge for single wire and stranded wire.

Table C. Wire Gauge

Wire Gauge (minimum allowable)

Single wire (solid)	24	AWG (0.25 mm2)
Stranded wire	24	AWG (1.0 mm2)
(flexible)

Figure 6 shows a wire assembly cable (part #WA01-5104-005AG) connecting four cameras to a CM9700UTP32A. Refer to Figure 5 and Table A for the RJ-45 pin designations.

100-240 VAC 50-60Hz 75A

CAMERA 4	PIN 5 +
	PIN 4 -

		WHITE/BROWN
CC3610/CC3710	8 PINS (4-/5+)	BROWN
SERIES CAMERA
	10 PINS (5-/6+)
CAMERA 3	BLUE	WHITE/BLUE
	WIRE = +
	GRAY	BLUE
	WIRE = -
CAMCLOSURE

CAMERA 2

	VC-UTP		WHITE/GREEN
	BOARD
					GREEN
SPECTRA®
CAMERA 1					ORANGE
FIXED CAMERA	TW4001P		WHITE/ORANGE
						WIRE
						ASSEMBLY
						CABLE
			1-4
1 17 2 18 3 19 4 20 5 21 6 22 7 23 8 24 9 25 10 26 11 27 12 28 13 29 14 30 15 31 16 32		TO MXB	1-4	5-8	9-12	13-16
			17-20	21-24	25-28	29-32
				CM9700-UTP32A

Figure 6. Using the Wire Assembly Cables

C3646M-C (6/09) 11