Motorola DSR205 manual Installation, Connecting the Satellite Dish, Receiver, and TV

1

Installation

Connecting the Satellite Dish, Receiver, and TV

Complete the following steps, and make sure that the satellite receiver is not plugged into a power source before you connect any cables to the receiver:

•Connect the cable from the satellite dish to the satellite terminal on the satellite receiver's back panel. Connect the supplied three-wire (red, yellow, and white) cable from the TV terminal on the satellite receiver's back panel to TV IN (or coaxial cable to VHF IN) terminal on your TV.

•On the back panel of the satellite receiver, set the CH3 CH4 switch which is located just above the TV terminal— to the same channel that you set on your TV for use with your VCR.

•Turn on the TV and tune it to channel 3 or 4 to match the position of the switch on the back panel of the satellite receiver.

•Plug the satellite receiver power cord into a standard power outlet. Wait one minute, and then press the POWER key on the left side of the satellite receiver's front panel.

1 2 3

DSR205 User Guide 1