Motorola M-Series owner manual Operations, Turn the Radio On/Off, Adjust the Volume, Scan Optional

OPERATIONS

Turn the Radio On/Off

Turn the On-Off/Volume knob clockwise. You will hear a beep and see the Transmit Light flash momentarily to indicate the radio is on. To turn the radio off, turn the On-Off/Volume knob counterclockwise. You will hear a click to indicate the radio is turned off.

Adjust the Volume

Hold Monitor button down to listen to audio level while rotating On-Off/Volume knob. Rotate knob clockwise to increase and coun- terclockwise to decrease volume.

To Send/Receive Messages

Check channel activity by pressing Monitor button. You will hear static if the channel is clear to use. Do not transmit if someone is talking on channel.

1.To send messages, press Push-To-Talk and speak into radio. (To maximize clarity, hold radio 1 to 2 inches from mouth). Fig. M

2.The Transmit Light will glow continuously when sending messages.

3.To listen for messages, release the Push-To- Talk button.

FIG. M

See page 15 for range information.

Time-out Timer:

The Time-out Timer feature prevents channel congestion and helps extend battery life. The radio will sound a warning tone if the Push- To-Talk button is pressed for 60 continuous seconds and will stop transmitting.

12

Scan (Optional)

Some M-Series models have Scan. Scan allows you to monitor the radio’s pro- grammed channels and code. When the radio detects someone talking, it stops scanning and locks in on the active chan- nel. It allows you to listen and talk back automatically to the person transmitting without having to switch channels.

Note: To communicate in scan, your radio must be set to the same frequency and code as the other radio(s) in your group.

To Use Scan Feature

1.Move the Channel Selector knob to the “s” position (Fig. N). The radio will scan the radio’s programmed channels and code in sequential order.

2.When the radio detects someone talking, you will hear the message.

3.Press Push-To-Talk button to talk back on the channel.

In scan,you will always transmit back to the channel which last sent a message.

	2	s
1

FIG. N 4 Channel Model

Notes:

•In scan, after you receive a message, the radio will remain on that channel for three seconds before returning to scan mode.

•If you set the Channel Selector knob to the “s” position (scan mode) and no activ- ity is detected, you will transmit on chan-

nel 1 when you press the Push-To-Talk