Motorola PTP 400 Series 7 Installation

7 Installation

Motorola recommends that only qualified personnel undertake the installation of a PTP 400

Series Bridge solution.

Before proceeding with the installation you should:

• Check the contents of all packages against the parts lists shown in the packing list.

• Ensure that you have the correct tools for the job.

• Ensure that you are qualified to undertake the work.

• Ensure that you have taken the correct safety precautions.

• Have completed the site planning as described in section 6 “Site Planning”.

The installation procedure for a PTP 400 Series system consists of the following steps:

• Mounting the ODUs, section 7.6

• Connecting up, section 7.7

• Mounting the PIDU Plus units, section 7.7.6

• Powering Up, section

7.7.9

• Aligning the ODUs, section 7.7.10

The following specific tools are required to install the PTP 400 Series Bridge in addition to

general tools:

• 13mm Spanner / Wrenche

• RJ45 Crimp Tool

• IBM Compatible Personal Computer (PC) running Windows 98 or later with 10 or

100baseT Ethernet (Ability to change IP settings easily is recommended)

• Either Internet Explorer version 6 or higher, or Mozilla Firefox v1.5 or higher are

recommended.

• Ethernet patch cable

• 6mm general purpose crimp tool for the grounding lug (optional for lightening Protection)