97
8.3.5.3 Wireless Configuration
A discussion of the wireless configuration and its relationship to the band of operations is
contained in section 5 “General Considerations”. It is recommended that the installer reads
this section before commencing with the product installation.
Step 2 of the installation wizard requires the installer to enter the wireless configuration
parameters:
Figure 44 - Installation Wizard Wireless Configuration
Target MAC Address: The MAC Address of the peer unit that will be at the other end of the
wireless link. This is used by the system to ensure the unit establishes a wireless link to the
correct peer.
The MAC Address can be found embedded within the serial number of the unit. The last six
characters of the serial number are the last three bytes of the unit’s MAC address.
Note: A PTP 400 Series system is shipped as a pair of units with pre-loaded correct MAC
addresses. MAC addresses will only need to be entered if an existing unit has to be replaced
in the field or the units configuration has been erased.