PROGRAMMING FEATURES
6.Place the Source radio” in its SUC, press and release SB1.
7.After cloning is completed, the Source radio will sound either a “pass” tone (cloning was successful) or a “fail” tone (cloning process has failed). The ‘pass’ tone sounds like a good key ‘chirp’ whereas the ‘fail’ tone sounds similar to a ‘bonk’ tone. If the Source radio is a display model it will either show ‘Pass’ or ‘Fail’ on the display (a tone will be heard in no more than 5 seconds).
8.Once you have completed the cloning process, turn the radios OFFand ON in order to exit ‘clone’ mode.
What to do if cloning fails
The radio will emit an audible ‘bonk’ indicating that the cloning process has failed. In the event that cloning fails, try performing each of the following before trying to start the cloning process again:
1.Ensure that the batteries on both radios are fully charged.
2.Check the cloning cable connection on both SUCs.
3.Ensure that the battery is engaged properly on to the radio.
4.Ensure that there is no debris in the charging tray or on the radio contacts.
5.Ensure that the Source radio is in cloning mode.
6.Ensure that the Target radio is turned ON.
7.Ensure both radios are both from the same type. (same frequency band, same front panel (display/non display), same region and same transmission power).
Attention: This cloning cable is designed to operate only with compatible Motorola RLN6170 (Rapid) Single Unit Charger.
When ordering Cloning Cable please refer to P/N RLN6303. For details about accessories refer to “Accessories” section.
English 52
