Install Remove | Motorola XTNID specs

BATTERIES AND CHARGERS

Power Supply, Adaptors and Drop-in Tray Charger

Power Supply

Drop-in Tray Charger

Adaptor

Adaptor

Your radio comes with one Drop-in Tray Charger, one Power Supply (also known as "transformer") and a set of adaptors.

Your power supply, has a "switchable" capability which allows to suit any of the adaptors that comes with your radio package. The adaptor you should choose to install depends on the region you're located.

Once you have identified the adaptor that matches your electrical outlet, proceed to install it as follows:

English 16

Power Supply

Power Supply

Install Remove

•Slide down the adaptor grooves into the power supply until it snaps into place.

•Slide the adaptor upward to remove.

Note: The adaptor shown in the pictures are just for illustration purposes. The adaptor you should install may be different.

Image 18

Motorola XTNID manual Install Remove, Power Supply, Adaptors and Drop-in Tray Charger

Contents

Page Page Contents Programming Features Getting Started Accessories Contents Computer Software Copyrights Computer Software Copyrights Safety Safety Batteries and Chargers Safety Information Batteries and Chargers Safety Information Operational Safety Guidelines Radio Overview Parts of the RadioRadio Radio Overview Lithium-Ion Li-Ion Battery Side Buttons Model Frequency Transmit Power Number Antenna Band Batteries and Chargers Battery Features and Charging OptionsAbout the Li-Ion Battery Batteries and Chargers Battery Recycling and Disposal Battery Latchbattery latch Slots Turn OFF the radio Batteries and Chargers Install Remove Power Supply, Adaptors and Drop-in Tray Charger Installing Spring Action Belt Clip Battery Life Information Following chart summarizes battery life estimations Charging the Battery Charging with the Drop-in Tray Single Unit Charger Charging a Stand-Alone Battery Charging a Standard Battery Adjustable bracket Standard High and Ultra High Capacity Charging a High Capacity Battery Drop-in Tray Charger LED Indicators Standard Charger LED Indicator Estimated Charging Time MUC LED Indicator Getting Started Adjusting VolumeGetting Started Turning Radio ON/OFF Selecting a Channel Talking and MonitoringReceiving a Call Signal Strength Indicator and Channel Busy Indicators Talk Range Getting Started Getting Started Radio LED Indicators Radio Status LED Indication With Compatible VOX Accessories HANDS-FREE USE/VOX Hands Free without Accessories iVOX Battery SaveReset To Factory Defaults Keypad Beeps Setting VOX/iVOX SensitivityEnd of Transmission Tone Roger Beep Tone Menu Options Setting VOX / iVOX sensitivity IVO Getting Started Imic YES Programming Features Entering Programming Mode Programming Features Programming RX Reception FrequenciesProgramming RX Reception Codes CTCSS/DPL RX BW Programming RX Reception Bandwidth Programming Scramble L Programming Maximum Number of Channels MA X CH Programming Call Tones Programming Microphone Gain Level YES Programming Scan List Programming Buttons Editing Channel Alias Name Nuisance Channel Delete Time-Out Timer CPS Computer Programming SoftwareBandwidth Select Battery Type Setting Call TonesScramble Programming Features Cloning Radios Cloning with a Multi-Unit Charger MUC Turn on the Target radio and place it Into one of the SUCs What to do if cloning fails Cloning Radios using the CPS Computer Programming Software Troubleshooting Troubleshooting Does not come on Cannot activate VOX USE and Care If the radio is submerged in waterUSE and Care Frequency and Code Charts Frequency and Code ChartsChannel Radios PMR 446 Defaults Ctcss DPL Codes 108 627 115 712 What is not Covered by the Warranty WarrantyWarranty Information Motorola Limited Motorola Limited Warranty Accessories Chargers Page 6871663M05