Manuals / Moyer Diebel / Kitchen Appliance / Dishwasher

Moyer Diebel 301HT M2 installation manual Receiving

Models: 301HT M2

1 50

Download 50 pages 12.29 Kb

Page 10

installation.

Installation

Receiving

Care should be taken when lifting the machine to prevent damage.

The machine is normally shipped on a skid enclosed by straps. When transporting the machine, use a lift truck or fork lift, positioning the box properly on the forks.

1.Immediately after unpacking your machine, inspect for any shipping damages. If damage is found, save the packing material and contact the carrier immediately.

2.Remove the dishwasher from the skid. Adjust the feet if required, then move the machine to its permanent location.

3.Level the machine (if required) by placing a level on the top if the machine and adjusting the feet. Level the machine front-to-back and side-to-side.

4.Remove any foreign material from inside of the machine.

Note:

Installers must follow applicable sanitation, safety, plumbing, and electrical codes

and regulations; and work in accordance with best practices for dishwasher

installation.

2

Image 10

Moyer Diebel 301HT M2 installation manual Receiving

Contents

Manual P/N 114150 rev. B Undercounter High Temperature DishwasherInstallation Manual with Service Replacement Parts 301HT M2Model Number Serial Number VoltageHertz Phase NO POSTAGE NECESSARY IF MAILED IN THE UNITED STATES BUSINESS REPLY MAILMOYER DIEBEL PO BOX 4183 WINSTON-SALEM, NC FIRST-CLASS MAIL PERMIT NO. 2101 WINSTON-SALEM, NCThis Card Must Be Returned to Validate Machine Warranty WARRANTY REGISTRATION CARDWARRANTY REGISTRATION CARD This Card Must Be Returned to Validate Machine WarrantyRevised Revision HistoryRevision Serial NumberLimited Warranty Limited WarrantyOperation Cleaning De-liming Maintenance Troubleshooting Table of ContentsInstallation Service Replacement PartsModel 301HT M2 Model DescriptionsOptions Receiving installation ReceivingElectrical Connections Water Connections Plumbing ConnectionsDrain Connections Rinse Aid Completing the InstallationDetergent Chemical DispensersInitial Start Up Initial Start-upInitial Start Up 1. The door must be closed to begin the cycleThis procedure is only needed when the tank is empty Operation ProceduresOperation Note DO NOT OVERLOAD the rackAfter Meal Periods or 8 Hours of Operation CleaningWeekly De-liming Procedure De-limingDanger Daily Maintenance MaintenanceCleaning Schedule Monthly MaintenanceCondition TroubleshootingSolution CauseWash water temperature too low TroubleshootingSolution Keep wash water as clean as possibleThis Page Intentionally Left Blank Blank PageIllustrations Service Replacement PartsPage Hood and Tank Assembly Description Item NoUnit Door Assembly H25791 Detergent Wash Tank Heater and Chemical Dispenserspump Rinse-aidSqueeze Tube, Detergent comes with black fittings Squeeze Tube, Rinse comes with black fittingsFill Piping Assembly H36156 To Drain Drain Assembly1614 H32796 Wash and Rinse Piping Assembly BOTTOM OF TAN0502563 Wash and Rinse Arm Assemblies Bearing, Wash Arm Wash Pump/Motor Assembly H36354 Booster Heater Assembly H36250 Control Panel Assembly Thermometer Does not include Item Start Switch Push button only does not include ItemBeginning with S/N 66190 and above Control Cabinet Assembly H160121 This page intentionally left blank Blank PageElectrical Schematic and Timing Chart Electrical Schematics and Timing ChartElectrical Schematic Timing Chart